The line protocol is down and I don't know what the connection is missing. Time since last interface status change: 00:19:34 Output 0 Mbits/sec, 0 packets/sec, 0% of line rate Input 0 Mbits/sec, 0 packets/sec, o% of line rate Last clearing of "show interface" counters: 00:19:33Ġ 64-byte pts, 0 over 64-byte pts, 0 over 127-byte ptsĠ over 255-byte pts, 0 over 511-byte pts, 0 over 1023-byte ptsĠ 64-byte pts, 0 over 64-byte pkts, 0 over 127-byte ptsĠ over 255-byte prts, 0 over 511-byte prts, 0 over 1023-byte ptsĠ throttles, 0 discarded, 0 collisions, wred drops Pluggable media present, SFP28 type is SFP28 25GBASE-LRĬonfigured FEC is off, Negotiated FeC is off Flowcontrol ry off tx off The status of the interface is: ToR1(conf-if-eth1/1/47)# do show interface ethernet 1/1/47Įthernet 1/1/47 is up, line protocol is down ![]() The configuration of the interface is: ToR1(conf-if-eth1/1/47)# show configuration It can't be the cable, because this cable works with the same SFP module in a DELL server without any problems. Unfortunately I don't get an uplink when I connect the switches. The DELL switch has a SFP module from DELL and the CISCO switch has one from CISCO. ![]() The connection should not be able to do much, it is enough if two VLANs are connected over it.īoth switches (DELL and CISCO) have 25GB ports and corresponding SFP modules. ![]() I am trying to connect one of my DELL S5248F-ON switches to an existing network with CISCO switches. How do you enable port security on Cisco switch (Cisco, switch, switching, Cisco catalyst, switchport, network engineering).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |